咨询与建议

看过本文的还看了

相关文献

该作者的其他文献

文献详情 >Novel Differential Protection ... 收藏

Novel Differential Protection Approach of UHV AC Transmission Lines Based on Tellegen's Quasi-Power Theorem

作     者:Liu, Shiming Wang, Bo Zhao, Yongsen Zhang, L. L. Jiang, L. 

作者机构:Shandong Univ Minist Educ Key Lab Power Syst Intelligent Dispatch & Control Jinan 250061 Peoples R China South China Univ Technol Sch Elect Power Engn Guangzhou 510640 Peoples R China Univ Liverpool Dept Elect Engn & Elect Liverpool L69 3GJ Merseyside England 

出 版 物:《IEEE TRANSACTIONS ON POWER DELIVERY》 (IEEE Trans Power Delivery)

年 卷 期:2022年第37卷第2期

页      面:1264-1274页

核心收录:

学科分类:0808[工学-电气工程] 08[工学] 

基  金:National Natural Science Foundation ofChina 

主  题:Circuit faults Power transmission lines Synchronization Impedance Transmission line measurements Equivalent circuits Relays Tellegen's quasi-power theorem differential protection ultra-high voltage protection relay 

摘      要:When current differential protection is applied to an AC transmission line, synchronous sampling at the two ends is required. The use of GPS synchronization increases the difficulty and cost of project implementation while the use of ping-pong synchronization requires that the communication channel has equal transmission and reception delay. To overcome the impact of these issues, power differential protection has been proposed. However, power differential protection cannot fully identify the fault zone for solid single-line-to-ground fault. This paper proposes a novel differential protection approach based on the Tellegen s quasi-power theorem. The approach retains the advantages of current differential protection. Meanwhile, it is not affected by load condition and distributed capacitance. This paper also proposes a time synchronization method based on the Tellegen s quasi-power theorem to calculate and correct the time synchronization error. Therefore, the proposed pilot protection has a high synchronization accuracy and has no requirement on the communication delay. In this paper, different simulation models are established by using MATLAB/Simulink and PSCAD and extensive simulation studies verify the effectiveness of the proposed protection approach and time synchronization method.

读者评论 与其他读者分享你的观点

用户名:未登录
我的评分