带电作业.电压检测器.两极低压型

标准编号：BS EN 61243-3-1999

提出单位：BSI

起草单位：BSI

发布日期：1999年

实施日期：19991015

主      题：电压 带电作业 使用说明 低压电源 安全 双极的 电压表 交流电压 电气设备 规范(验收) 电气安全 防事故 工作场所安全 电网 电压测试器 电气工程 定义 定义 设计 试验 

中国标准分类号：K04

国际标准分类号：13_260

摘      要：This part of IEC 61243 is applicable to two-pole voltage detectors to be used on electrical systems for nominal voltages not exceeding 1 000 V a.c. and/or 1 500 V d.c. and below 500 Hz (nominal frequencies). The detector types are classified as follows: voltage class A: up to and including 500 V a.c/750 V d.c; voltage class B: up to and including 1 000 V a.c/1 500 V d.c. This part of IEC 61243 also applies to supplementary functions such as phase indications, rotating field indications, and continuity checks (see annex E). Furthermore, it applies to accessories such as crocodile clips, detachable leads and contact electrode extensions. Unless otherwise specified, all the voltages defined in this standard refer to phase-to-phase voltages of three-phase systems. Detectors may be used in other than three-phase systems, then the applicable phase-to-phase or phase-to-earth (ground) voltages are to be used to determine the operating voltage. Low-voltage detectors covered by this standard are not intended to provide measurement of absolute values. Measuring devices are excluded from this standard. NOTE - The requirements for measuring devices are specified in IEC 61010-1 and IEC 61010-2-031.