检索结果-内蒙古大学图书馆

UAV longitudinal autopilot design using SLC and TECS controllers

CEAS Aeronautical Journal 2024年第2期15卷 351-362页

作者： Ghelem, Nourddine Boudana, Djamel Bouchhida, Ouahid Laboratory of Process Control LCP Department of Engineering Control Systems and Applied Mathematics National Polytechnic School ENP of Algiers 10 St Hacen Badi El Harrach Algiers Algeria Department of Electrical Engineering LREA Laboratory University of Medea Medea Algeria

UAVs are becoming increasingly prevalent in a wide range of fields, including surveillance, photography, agriculture, transportation, and communications. Hence, research institutions have developed a range of linear and non-linear controllers that can enhance the stability and efficiency of these UAVs while performing their assigned tasks. In this paper, we present a longitudinal autopilot design for the Sky Sailor solar UAV using two different control techniques. The first technique is a classic controller known as SLC (Successive Loop Closure), which is based on consecutive closed loops using a PID controller. The second technique is the TECS (Total Energy control System) controller, which uses the specified total energy rate and energy distribution rate to regulate the airspeed and altitude of the UAV. After detailing the working principle of each controller and calculating the tuning parameters for each one, we applied the two techniques to the non-linear model that describes the behavior of the Sky Sailor UAV using MATLAB Simulink. The simulation results showed that the TECS controller is superior to the SLC controller in terms of stability and energy efficiency. As such, this technique is an excellent choice for solar drones, as it can increase their endurance. © Deutsches Zentrum für Luft- und Raumfahrt e.V. 2024.

关键词： controllers

来源：评论

学校读者我要写书评

暂无评论

Sliding mode active disturbance rejection control for uncalibrated visual servoing

引用

International Journal of Systems, control and Communications 2025年第2期16卷 133-151页

作者： Pu, Cuiping Wu, Yi Ren, Jie Ran, Chenyang College of Mechanical and Electrical Engineering Kunming University Kunming China School of Information and Control Engineering China University of Mining and Technology Xuzhou China Department of Automation Shanghai Jiao Tong University Shanghai China

A sliding mode control algorithm based on a linear extended state observer is proposed to address the multi-source uncertainty of uncalibrated visual servoing in robotic arms. Uncertainty, nonlinearity, coupling, external disturbances, etc. are considered as total disturbances. The linear expansion state observer is designed to observe the total disturbance and compensate for it. This enhances the system’s anti-interference ability. The outer loop adopts sliding mode control law as state feedback. It suppresses the observation errors of the observer and ensures the stability of the system. Sliding mode control based on linear extended observer does not depend on specific tasks and system configurations. It provides a unified design framework for solving the problem of uncalibrated visual servoing. Through numerical simulations of three different disturbance cases, it was compared with PI linear extended state observer and linear active disturbance rejection to verify its good dynamic performance and disturbance rejection performance. Copyright © 2025 Inderscience Enterprises Ltd.

关键词： Robotic arms

来源：评论

学校读者我要写书评

暂无评论

Observer-based stabilization for discrete nonlinear semi-Markov jump singularly perturbed models with mode-switching delay

引用

Science China(Information Sciences) 2025年第4期68卷 389-390页

作者： Wenhai QI Runkun LI Ju H.PARK Zheng-Guang WU Huaicheng YAN School of Engineering Qufu Normal University Department of Electrical Engineering Yeungnam University Institute of Cyber-Systems and Control Zhejiang University Key Laboratory of Smart Manufacturing in Energy Chemical Process of Ministry of Education East China University of Science and Technology

Semi-Markov jump systems(S-MJMs) not only characterize hybrid systems but also address the limitations of Markov jump systems(MJMs) [1–3]. Due to their ability to exhibit multi-time-scale features, singularly perturbed models(SPMs) effectively model practical systems influenced by multiple time-scale phenomena [4]. In this study, the observer-based output feedback controller is asynchronous with the original system due to the time delay in the controller mode switching. A nonlinear plant with singularly perturbed parameters(SPPs) is represented using an interval type-2(IT2) fuzzy model [5].

关键词：

来源：评论

学校读者我要写书评

暂无评论

Stability and bifurcation analysis of delayed tri-trophic food chain model in poisoned environment with fear effect and additional food

Stability and bifurcation analysis of delayed tri-trophic fo...

引用

作者： Ramasamy, Sivasamy Banjerdpongchai, David Park, PooGyeon Center of Excellence in Intelligent Control Automation of Process Systems Department of Electrical Engineering Faculty of Engineering Chulalongkorn University Bangkok Thailand Department of Electrical Engineering Pohang University of Science and Technology Pohang Korea Republic of

One of the most important goals of theoretical ecologists is to find a strategy for controlling the chaos in ecological models to maintain healthy ecosystems. We investigate the influence of fear and the supply of additional food to predators in a delayed tri-trophic food chain model, where interference among the species is determined by Holling type-II functional response. The proposed model incorporates the fact that the growth rates of prey and middle predators are decreased due to the fear of middle and special predators, respectively. The additional food is supplied to both predators by either nature or external agencies. Furthermore, the poisoned prey in the predator's environment is taken into account. In the proposed model, we use two time delays: one for the growth term of the middle predator and another for the gestation delay of the special predator. We determine the conditions for the existence of ecologically feasible equilibrium points and their local and global stability. In addition, we establish the conditions for the existence of Hopf bifurcation around interior equilibrium to seek periodic behavior in nondelayed and delayed models. Numerical investigations are performed to justify the proposed theoretical findings through phase portraits, time series of solutions, and bifurcation diagrams. We observe that the chaotic dynamics of a tri-trophic food chain model can be controlled by the proper choice of the fear effect and by supplying additional food parameters. As a result, our findings provide more ecological insights into the dynamics of the delayed tri-trophic food chain model with the fear effect and additional food supply. © 2023 John Wiley & Sons, Ltd.

关键词： Hopf bifurcation

来源：评论

学校读者我要写书评

暂无评论

Development of Motion Analysis Tool for Orthopedic Diseases: Inertial Measurements 6th

Development of Motion Analysis Tool for Orthopedic Diseases:...

引用

6th Computational Methods in Systems and Software, CoMeSySo 2022

作者： Jicinsky, Pavel Mares, Jan Department of Process Control Faculty of Electrical Engineering and Informatics University of Pardubice Pardubice Czech Republic

ISBN: (纸本)9783031214349

Rehabilitation in orthopedics is one of the most important processes that influence the patient’s quality of life. In today’s practice, the orthopedic assessments still depend mainly on subjective view of physician. To further objectify the results, a wearable electronic device was developed based on inertial sensors. © 2023, The Author(s), under exclusive license to Springer Nature Switzerland AG.

关键词： IMU Motion analysis Orthopedics Signal acquisition and processing

来源：评论

学校读者我要写书评

暂无评论

Real-time power flow analysis and management for a long-endurance solar UAV during continuous flight

引用

CEAS Aeronautical Journal 2023年第4期14卷 1035-1049页

One of the primary challenges for Unmanned Aerial Vehicle (UAV) developers is to improve their endurance while in the air, as their typical flight time is limited to a few hours. One widely used technology to enhance their endurance is harnessing solar energy to power UAV and charge their batteries in flight. This article presents the development of a real-time simulation environment to enable the continuous flight of the Sky Sailor solar UAV. Through the utilization of a solar irradiance model, a solar panel model, real-time power generation is calculated. Simultaneously, the UAV’s full dynamic model, along with the autopilot and propulsion system model, is employed to determine the energy consumption at each moment. The energy management algorithm then compares the acquired energy with the power consumed, and in cases of surplus energy, it is efficiently stored in the battery for nighttime usage. Simulations show that continuous flight of the drone can be achieved during the summer season, when the daylight hours are long enough to fully charge the battery, With the ability to fly continuously during this period, the UAV can be used in various areas, such as monitoring forest fires, agricultural fields, beaches, and security monitoring for oil companies and their life bases in deserts. © 2023, Deutsches Zentrum für Luft- und Raumfahrt e.V.

关键词： Solar energy

来源：评论

学校读者我要写书评

暂无评论

Robust control of Manned Submersible Vehicle With Nonlinear MPC and Disturbance Observer

引用

IEEE/CAA Journal of Automatica Sinica 2023年第5期10卷 1349-1351页

作者： Qiuxin Zhong Xing Fang Zhengtao Ding Fei Liu the Key Laboratory of Advanced Process Control for Light Industry of the Ministry of Education Jiangnan UniversityWuxi 214122China the Department of Electrical and Electronic Engineering University of ManchesterManchester M139PLUK

Dear Editor,This letter focuses on the trajectory tracking of 7000 m JIAOLONG manned submersible vehicle(MSV)with *** robust controller is realized by a composite control law,where an analytical nonlinear model predic... 详细信息

关键词： Nonlinear letter law

来源：评论

学校读者我要写书评

暂无评论

Self-Triggered Consensus Filtering over Asynchronous Communication Sensor Networks

引用

Computer Modeling in engineering & Sciences 2023年第2期134卷 857-871页

作者： Huiwen Xue Jiwei Wen Akshya Kumar Swain Xiaoli Luan Key Laboratory of Advanced Process Control for Light Industry(Ministry of Education) Jiangnan UniversityWuxi214000China Department of Electrical Computer and Software EngineeringUniversity of AucklandAuckland0632New Zealand

In this paper,a self-triggered consensus filtering is developed for a class of discrete-time distributed filtering *** from existing event-triggered filtering,the self-triggered one does not require to continuously judge the trigger condition at each sampling instant and can save computational burden while achieving good state *** triggering policy is presented for pre-computing the next execution time for measurements according to the filter’s own data and the latest released data of its neighbors at the current ***,a challenging problem is that data will be asynchronously transmitted within the filtering network because each node self-triggers ***,a co-design of the self-triggered policy and asynchronous distributed filter is developed to ensure consensus of the state ***,a numerical example is given to illustrate the effectiveness of the consensus filtering approach.

关键词： Self-triggered policy sensor networks distributed consensus filtering

来源：评论

学校读者我要写书评

暂无评论

Parameter estimation in solar power plant systems: a comparative study of recursive and iterative techniques

引用

Sustainable Energy Research 2024年第1期11卷 1-12页

作者： Sadeghi, Kiavash Hossein Shafikhah, Mahmood Marashian, Arash Roshandel, Emad Razminia, Abolhassan Department of Electrical Engineering Faculty of Intelligent Systems Engineering and Data Science Persian Gulf University Bushehr Iran Process Control Laboratory Faculty of Natural Sciences and Engineering Åbo Akademi University Turku Finland College of Science and Engineering Flinders University Adelaide Australia

The development of a dynamic model for a popular implemented solar power plant is a critical task for power engineers aiming to enhance the plant’s performance and reliability. In this study, we utilized the prediction error method (PEM), a robust algorithm for system identification, to capture the plant’s operational characteristics with precision. Additionally, we employed both recursive and hierarchical algorithms to identify the system parameters effectively. The results from each identification method are rigorously quantified and analyzed, allowing for a detailed comparison of their performance. This comprehensive evaluation not only highlights the strengths and weaknesses of each approach, but also provides valuable insights into their practical applications in the context of solar power systems. © The Author(s) 2024.

关键词：

来源：评论

学校读者我要写书评

暂无评论

Design of Supervisory Model Predictive control for HVAC Systems and Two Zones with Consideration of Energy Efficiency and Thermal Comfort 23

Design of Supervisory Model Predictive Control for HVAC Syst...

引用

23rd International Conference on control, Automation and Systems, ICCAS 2023

作者： Srisurapanon, Panithan Banjerdpongchai, David Chulalongkorn University Center of Excellence in Intelligent Control Automation for Process Systems Faculty of Engineering Department of Electrical Engineering Pathumwan Bangkok10330 Thailand

ISBN: (纸本)9788993215274

This paper presents the design of supervisory model predictive control for HVAC systems and two zones. The supervisory control (SC) is designed to find the optimal reference temperature of each zone. The design criteria consist of the total operating cost (TOC) and the thermal comfort cost (TCC). Then, the model predictive control (MPC) is designed to track the optimal reference signals. When SC and MPC are designed for two zones simultaneously, they are referred to centralized SC and centralized MPC. On the other hand, when SC and MPC are designed for two zones separately, they referred to decentralized SC and decentralized MPC. We then compare the results between the decentralized control and the centralized control. The trade-off curve shows that the performance of centralized control is better than that of decentralized control. In particular, centralized MPC improves the performance in tracking reference signals. Furthermore, TOC of centralized control is lower than that of decentralized control. It can be concluded that the centralized control is appropriate for two zones in terms of the tracking of reference and the electrical charge. © 2023 ICROS.

关键词： Model predictive control

来源：评论

学校读者我要写书评

暂无评论

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案：

请选择收藏分类：

通借通还

建议与咨询 留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案： 新增检索档案 确定 取消

请选择收藏分类： 新增自定义分类 确定 取消

通借通还

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

请选择保存的检索档案：

请选择收藏分类：