检索结果-内蒙古大学图书馆

3rd IFAC Workshop on Automatic Systems for Building the Infrastructure in Developing Countries, DECOM-TT 2003

作者： Dimirovski, Georgi M. Jing, Yuan-Wei Zhao, Jun Zhang, Si-Ying Dogus University Department of Computer Engineering Faculty of Engineering Acibadem Kadiköy IstanbulTR-34722 Turkey SS Cyril and Methodius University Institute of Automation and Systems Eng Faculty of Electrical Engineering SkopjeMK-1000 Macedonia Northeastern University Institute of Control Science School of Information Science and Eng. Shenyang Liaoning China

A control systems engineering approach, employing a two-level overall system architecture and different but compatible formalisms for system representation on the upper and lower levels, has been investigated in detail. One design alternative is based on employing fuzzy-system approximators and solving for the adaptive tracking of the given, arbitrary, desired system outputs. The other alternative is based on state equations of composite systems and the use of neural-network approximators to deal with uncertainties and control adaptation. In both alternatives similarity property of subsystems has been exploited. Both designs can be implemented within the standard computer process control technology, and are therefore believed to be promising in applied systems engineering. Copyright © 2003 IFAC.

关键词： Fuzzy systems

来源：评论

学校读者我要写书评

暂无评论

Optimization of PM brushless DC motor drive

Optimization of PM brushless DC motor drive

引用

IEEE International Conference on Industrial Technology (ICIT)

作者： P. Crnosija T. Bjazic R. Krishnan Faculty of Electrical Engineering and Computing Department of Control and Comp. Eng. in Automation University of Zagreb Zagreb Croatia The Bradley Department of Electrical and Computer Engineering Virginia Polytechnic Institute and State University Blacksburg VA USA

Traditional approaches to controller designs that guarantee fast compensation of load torque and reference variations result in design iterations and most of the time in poorer response for load torque variations. In this paper a reference model for desired drive behavior generation and optimization methods has been applied to achieve controller integral time constant lower than the maximum time constant of the PM brushless DC motor drive. Presented simulation results show that using reference model for desired drive behavior generation, it is possible to determine optimal controller parameters for faster (10 time) and better (2 time) load torque compensation than in the case of traditional design of speed controller parameters. Response due to reference input with constrained overshoot has been achieved using a filter in the servosystem input. Thereby, the proposed method demonstrates the design of a speed controller that is optimal for both load torque and reference variations and its verification with simulation are accomplished for a permanent magnet brushless dc motor drive.

关键词： Brushless DC motors Torque control Optimal control Time factors DC generators Optimization methods Magnetic separation Filters Servosystems Design methodology

来源：评论

学校读者我要写书评

暂无评论

Composite systems control by combined math-analytical and FS/NN computing approach

引用

IFAC Proceedings Volumes 2003年第7期36卷 7-18页

作者： Georgi M. Dimirovski Yuan-Wei Jing Jun Zhao Si-Ying Zhang Dogus University Department of Computer Engineering Faculty of Engineering Acibadem Kadiköy TR-34722 Istanbul Turkey Fax# +90-216-327-9631 SS Cyril and Methodius University Institute of Automation & Systems Eng. Faculty of Electrical Engineering MK-1000 Skopje R. of Macedonia Northeastern University Institute of Control Science School of Information Science & Eng. Shenyang Liaoning P.R. of China Fax# +90-24-2389-0912

关键词： Complex composite systems fuzzy systems neural networks nonlinear systems

来源：评论

学校读者我要写书评

暂无评论

A reinforcement learning approach to obstacle avoidance of mobile robots

A reinforcement learning approach to obstacle avoidance of m...

引用

International Workshop on Advanced Motion control (AMC)

作者： K. Macek I. Petrovic N. Peric Faculty of Electrical Engineering and Computing Department of Control and Computer Engineering in Automation University of Zagreb Croatia

One of the basic issues in the navigation of autonomous mobile robots is the obstacle avoidance task that is commonly achieved using a reactive control paradigm where a local mapping from perceived states to actions is acquired. A control strategy with learning capabilities in an unknown environment can be obtained using reinforcement learning where the learning agent is given only sparse reward information. This credit assignment problem includes both temporal and structural aspects. While the temporal credit assignment problem is solved using core elements of the reinforcement learning agent, solution of the structural credit assignment problem requires an appropriate internal state space representation of the environment. In this paper, a discrete coding of the input space using a neural network structure is presented as opposed to the commonly used continuous internal representation. This enables a faster and more efficient convergence of the reinforcement learning process.

关键词： Learning Mobile robots control engineering computing Automatic control Neural networks Fuzzy logic Path planning Robotics and automation Navigation State-space methods

来源：评论

学校读者我要写书评

暂无评论

Input reconstruction by means of system inversion: Application to fault detection and isolation 15th

Input reconstruction by means of system inversion: Applicati...

引用

15th World Congress of the International Federation of Automatic control, 2002

作者： Szigeti, F. Bokor, J. Edelmayer, A. Systems and Control Laboratory Computer and Automation Research Institute Hungarian Academy of Sciences Kende u. 13-17 BudapestH-1111 Hungary Department of Control Engineering Faculty of Engineering University of Los Andes Mérida A.P. 11 La Hechicera Venezuela

ISBN: (纸本)9783902661746

This paper attempts to look at the fundamental problem of fault detection and isolation (FDI) in nonlinear systems. Using the idea of input reconstruction by means of dynamic inversion the authors first discuss the properties of input (or fault) observability in linear systems. The extension of the results to nonlinear systems as well as the mathematical conditions of the calculation of the inverse system, which provides the inverse in finite algorithmic steps, are given. The applicability of the inversion process to fault reconstruction in nonlinear systems is demonstrated. Copyright © 2002 IFAC.

关键词： Fault detection

来源：评论

学校读者我要写书评

暂无评论

ATM available bit rate congestion control with on-line network model identification

ATM available bit rate congestion control with on-line netwo...

引用

IEEE International Conference on Electronics, Circuits and Systems (ICECS)

作者： D. Brscic I. Petrovic N. Peric Faculty of Electrical Engineering and Computing Department of Control and Computer Engineering in Automation University of Zagreb Zagreb Croatia

In this paper, the design of available bit rate (ABR) congestion control in ATM (asynchronous transfer mode) networks is considered. The goals of congestion control are high link utilization, low cell loss, and low network delay. Various algorithms for congestion control can be found in the literature. Most of them are based on a network model, which is assumed to be known. In this paper a recursive least square (RLS) algorithm for on-line identification of the network model is implemented and combined with a generalized predictive controller (GPC) and with an I-controller based on the Smith predictor. Simulations were carried out to prove the effectiveness of the proposed algorithms.

关键词： Bit rate Asynchronous transfer mode Traffic control Automatic control Communication system traffic control control design Bandwidth Switches Process control control engineering computing

来源：评论

学校读者我要写书评

暂无评论

Experimental investigations of the rubber-asphalt sliding pair dynamics

Experimental investigations of the rubber-asphalt sliding pa...

引用

作者： Božić, Ante Petrović, Ivan Perić, Nedjeljko Matuško, Jadranko Poclain-Hydraulics Industrie Direction Technique B.P.N. 106 60411 Verberie Cedex France University of Zagreb Faculty of Electrical Engineering and Computing Department for Control and Computer Engineering in Automation Unska 3 HR-10000 Zagreb Croatia

ISBN: (纸本)0791836290

A laboratory model for experimental investigations of the rubber-asphalt sliding pair has been designed with the purpose of better understanding of dynamic behavior of the friction force in the contact patch between the car tire and the road. Its design is described and some experimental results are given. These results confirm that it is essential to use a dynamic friction model in order to describe friction force in contact between the car tire and the road. Moreover, they indicate that the existing dynamic friction models might be physically incorrect regarding the change of friction coefficient for an asperity bristle passing through the contact surface. Copyright © 2002 by ASME.

关键词： Tribology

来源：评论

学校读者我要写书评

暂无评论

Toolkit for PID dominant pole design

Toolkit for PID dominant pole design

引用

IEEE International Conference on Electronics, Circuits and Systems (ICECS)

作者： I. Branica I. Petrovic N. Peric Systemcorn Zagreb Croatia Department of Control and Computer Engineering in Automation Faculty of Electrical Engineering and Computing University of Zagreb Zagreb Croatia

This work presents dominant pole design (DPD) methodology, one MATLAB implementation of DPD and its usage. DPD for PI and PID controllers is derived, and on this basis MATLAB toolkit for three-pole method (3PM) has been developed. The least squares procedure for finding functional dependence of PID controller parameters on process parameters is described. This least squares procedure has been applied to the first order process with dead time (FODT) obtained functional dependence, expressed through tuning formulas, is presented. Performance of PID controller tuned with 3PM tuning formulas is compared to the performance of PID controller tuned with integral criteria derived tuning formulas. Observed characteristics of DPD method are given at the end of the paper.

关键词： Three-term control control systems Design methodology MATLAB Equations Automatic control Least squares methods Process control Industrial control State feedback

来源：评论

学校读者我要写书评

暂无评论

INPUT RECONSTRUCTION BY MEANS OF SYSTEM INVERSION: APPLICATION TO FAULT DETECTION AND ISOLATION

引用

IFAC Proceedings Volumes 2002年第1期35卷 13-18页

作者： F. Szigeti J. Bokor A. Edelmayer Department of Control Engineering Faculty of Engineering University of Los Andes Mérida A.p. 11 La Hechicera Venezuela Systems and Control Laboratory Computer and Automation Research Institute Hungarian Academy of Sciences Budapest Kende u. 13–17 H-1111 Hungary

关键词： Fault detection and isolation Input observability Input reconstruction Inverse system Linear and non-linear systems

来源：评论

学校读者我要写书评

暂无评论

On complex non-linear systems with symmetries: controllability preserving decomposition

On complex non-linear systems with symmetries: controllabili...

引用

IEEE International Conference on Electronics, Circuits and Systems (ICECS)

作者： G.M. Dimirovski Y.-W. Jing J. Zhao T.D. Kolemisevska-Gugulovska Institute of Automation & Systems Engineering Faculty of Electrical Engineering Ss Cyril and Methodius University Skopje Macedonia Department of Computer Engineering Faculty of Engineering Dogus University Istanbul Turkey Institute of Control Science School of Information Science & Engineering Northeastern University Shenyang Liaoning China Institute of Automation & Systems Engineering Faculty of Electrical Engineering Ss Cyril and Methodius University Skopje Macedonia

In this paper, the problems of isomorphic decomposition and controllability of a class of nonlinear systems possessing symmetries, on the basis of quotient systems, is studied. The isomorphic decomposition formations of these systems are derived. Finally, it is shown that controllability of the original systems can be determined by that of the subsystems, which are obtained through isomorphic decomposition. The corresponding sufficient and necessary conditions are given. Two new theoretical results have been proved.

关键词： controllability Nonlinear control systems control systems Nonlinear systems Automatic control Information science automation Systems engineering and theory Feedback Mathematical model

来源：评论

学校读者我要写书评

暂无评论

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案：

请选择收藏分类：

通借通还

建议与咨询 留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案： 新增检索档案 确定 取消

请选择收藏分类： 新增自定义分类 确定 取消

通借通还

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

请选择保存的检索档案：

请选择收藏分类：