Large fraction of the low-pressure turbine cascade boundary layer is laminar flow due to low Reynolds number. High-lift low-pressure turbine blade leads to increase the adverse pressure gradient at rear of the turbine...
详细信息
Water wall design is a key technology of supercritical pressure CFB boiler. On account of the low heat flux and its homogeneous distribution in furnace, internally ribbed tubes with low mass flux and smooth tubes with...
详细信息
Water wall design is a key technology of supercritical pressure CFB boiler. On account of the low heat flux and its homogeneous distribution in furnace, internally ribbed tubes with low mass flux and smooth tubes with moderate mass flux can be applied in the water wall of supercritical CFB boilers. An experimental research on the flow and heat transfer characteristics of internally ribbed tubes and smooth tubes with different inner diameters was conducted in the range of sub-critical and supercritical pressure. The departure from nucleate boiling (DNB) and dry-out boundary and the empirical correlations of heat transfer are obtained from the experiments. The mathematical model for predicting the circuit mass flux and grid pressure of a flow network system is based on the mass and momentum conservation equations and an iterative method is used to solve the nonlinear equations. Harbin Boiler Works has developed a 600MW supercritical CFB boiler with external heat exchangers and 6 separators. The mass flux and metal temperature distribution of water wall in the CFB boiler are calculated and the results show that the water wall can operate safely at BMCR and 75%BMCR load.
Two-phase flow instability in parallel multi-channel system was studied under rolling motion condition. A parallel nine-channel model was established by using the control volume integrating method based on the homogen...
详细信息
Two-phase flow instability in parallel multi-channel system was studied under rolling motion condition. A parallel nine-channel model was established by using the control volume integrating method based on the homogeneous flow model with considering the rolling motion condition. The gear method was used to solve the control equations. The influences of the entrance, upward sections and the heating power on the flow instability under rolling motion condition were analyzed. The marginal stability boundary (MSB) under rolling motion condition was obtained. The unstable regions occur in both low and high equilibrium quality regions. The region with low inlet sub-cooling is also unstable. In high equilibrium quality region, the multiplied period phenomenon is found and the chaotic phenomenon appears at the MSB.
One set of one-dimensional unsteady homogenous mathematic models for flow and heat process of natural circulation precooling loop of cryogenic liquid rocket engine was established, whilst both inverted annular model a...
详细信息
One set of one-dimensional unsteady homogenous mathematic models for flow and heat process of natural circulation precooling loop of cryogenic liquid rocket engine was established, whilst both inverted annular model and dispersed model were introduced for the prediction of filming boiling region. The results indicate the unstable characteristics of circulation flow rate in precooling process is caused by the unstable characteristics of natural circulation driving force, that is, the heat flux transferred to the cryogenic liquid from the natural circulation precooling loop. Moreover, about 80% of wall temperature drop takes place in filming boiling region, and the inverted temperature distribution law of the return pipe is well interpreted by introducing the two filming boiling models mentioned above.
Low-pressure premixed laminar flames of 1,3-butadiene/oxygen /argon and 1,3-butadiene+acetylene/oxygen/argon have been investigated with tunable synchrotron photoionization and molecular beam mass spectrometry. Flame ...
详细信息
Low-pressure (4.0 kPa) premixed laminar 2,5-dimethylfuran (DMF)/oxygen/argon flame with an equivalence ratio (ø) of 2.0 was studied with tunable vacuum ultraviolet synchrotron radiation photoionization and molecu...
详细信息
Chokes are one of the most important components of downhole flow-control equipment. The particle erosion mathematical model, which considers particle-particle interaction, was established and used to simulate solid pa...
详细信息
Chokes are one of the most important components of downhole flow-control equipment. The particle erosion mathematical model, which considers particle-particle interaction, was established and used to simulate solid particle movement as well as particle erosion characteristics of the solid-liquid two-phase flow in a choke. The corresponding erosion reduction approach by setting ribs on the inner wall of the choke was advanced. This mathematical model includes three parts: the flow field simulation of the continuous carrier fluid by an Eulerian approach, the particle interaction simulation using the discrete particle hard sphere model by a Lagrangian approach and calculation of erosion rate using semiempirical correlations. The results show that particles accumulated in a narrow region from inlet to outlet of the choke and the dominating factor affecting particle motion is the fluid drag force. As a result, the optimization of rib geometrical parameters indicates that good anti-erosion performance can be achieved by four ribs, each of them with a height (H) of 3 mm and a width (B) of 5 mm equaling the interval between ribs (L).
Low pressure premixed laminar n-heptane/propane/O2/N2 flames were investigated with tunable synchrotron vacuum ultraviolet (VUV) photoionization and molecular-beam sampling mass spectrometry. Three flames with differe...
详细信息
To improve the efficiency of parameters selection for support vector machines(SVM),a novel method of Levenberg-Marquardt(LM) algorithm coupling with SVM,called LM/SVM,was developed in this *** new method was applied i...
详细信息
To improve the efficiency of parameters selection for support vector machines(SVM),a novel method of Levenberg-Marquardt(LM) algorithm coupling with SVM,called LM/SVM,was developed in this *** new method was applied in modeling and optimization for increasing propylene in secondary reaction of FCC *** LM algorithm was adopted in LM/SVM method to optimize the multiple parameters of the SVM model as to overcome the problem of difficult to selecting the parameters for SVM and to fit relational expression of high *** strategy which divided the training data into working data to train SVM and the testing data to avoid over-fitting was *** of LM/SVM with reported genetic algorithm based support vector regression indicated that LM/SVM had better generalization ability and higher *** performance of LM/SVM employing polynomial kernel was *** agreement between predicted results and experimental data suggested that the LM/SVM method was successfully developed and the SVM model for increasing propylene was well *** quadratic programming(SQP) algorithm was employed to optimize the operation conditions for maximizing the propylene yield of secondary *** proposed model was claimed to accurately predict the yields of propylene and liquefied petrochemical gas(LPG).
A set of linearized 26 moment equations, along with their wall boundary conditions, are derived and used to study low-speed gas flows dominated by Knudsen layers. Analytical solutions are obtained for Kramers' def...
详细信息
暂无评论