Ga dopping GaxPb1-xTe(x=0.01-0.05) compounds were prepared by melting reaction method, and the in-c fluence of Ga content on the thermoelectric properties were investigated. The results showed that temperature dopende...
详细信息
Ga dopping GaxPb1-xTe(x=0.01-0.05) compounds were prepared by melting reaction method, and the in-c fluence of Ga content on the thermoelectric properties were investigated. The results showed that temperature dopendent carrier concentration increased and the hall mobility decreased with increasing Ga content, which indicated that the carrier scattering mechanism gradually changed from an acoustical scattering to the interaction between an acoustical phone and an ionized impurity scattering as x increased. All samples show n-type conduct and the absolute Seebeck coefficient values and the electric conductivity increase significantly with increasing Ga content.
The layered perovskite-type organic-inorganic hybrids (CnH2n+1NH3)2 MnCl4 (n=2, 4, 6, 8, 10, 12) were synthesized in solution and their structures were characterized. The results showed that the structures of the prod...
详细信息
The layered perovskite-type organic-inorganic hybrids (CnH2n+1NH3)2 MnCl4 (n=2, 4, 6, 8, 10, 12) were synthesized in solution and their structures were characterized. The results showed that the structures of the products were independent on the reaction initial temperature. The X-ray diffraction (XRD) patterns and the scanning electron microscopy (SEM) images of the products demonstrated that the hybrids crystallize very well and had typical layered structures. The interlayer distance of each hybrid was obtained from the XRD patterns. It was linear dependent on the carbon atom number in the organic chain and the organic chains interdigitated between the two adjacent inorganic sheets.
The solubility of layered perovskite-type organic-inorganic hybrids (CnH2n+1 NH3)2MCl4 (where M = Mn, Co, Cu, Zn;n = 2, 4, 6, 8, 10, 12) in seven kinds of solvent are obtained by atomic absorption spectrometry and tit...
详细信息
The solubility of layered perovskite-type organic-inorganic hybrids (CnH2n+1 NH3)2MCl4 (where M = Mn, Co, Cu, Zn;n = 2, 4, 6, 8, 10, 12) in seven kinds of solvent are obtained by atomic absorption spectrometry and titration method. The solvents are sherwood oil, cyclohexane, acetone, trichloromethane, DMF, methanol and water. The results show that the hybrids are prone to dissolve in polar solvent. This is attributed to the polarity of the hybrids. The hybrids disassembly dissolve when the interaction between the ammonium and the electron-donating group of the solvent is stronger than that between the organic and the inorganic parts in the hybrids. The series of M = Zn and Co have better solubility in the polar solvent than that of M = Mn and Cu and this is presumably because there are weaker interactions between the organic and inorganic parts in hybrids of M = Zn and Co.
A novel process was introduced in this paper for the diameter-controlling synthesis of carbon nanofibers (CNFs) in the ethanol flames. The carbon nanofibers were grown on a nanocrystalline Fe layer, which was electro-...
A novel process was introduced in this paper for the diameter-controlling synthesis of carbon nanofibers (CNFs) in the ethanol flames. The carbon nanofibers were grown on a nanocrystalline Fe layer, which was electro-deposited on a substrate using periodic reverse (P.R.) pulse plating. It was found that the quality of the plating nanocrystalline and the corresponding carbon nanofibers was related with two plating parameters: output pulse frequency ( f ) and duty cycle ( r ). In addition to that the straight and helical carbon nanofibers were selectively synthesized by addition of different additives in plating bath. In this paper, the base-growth mechanism of carbon nanofibers was clearly discussed.
Using the microwave sintering technology, the effects of phosphorus （P） additions on the microstructure and properties of the ultrafine WC-10Co alloys were investigated. The experimental results show that with only ...
详细信息
Using the microwave sintering technology, the effects of phosphorus （P） additions on the microstructure and properties of the ultrafine WC-10Co alloys were investigated. The experimental results show that with only 0.3wt% P additions, full density WC-10Co cermets were obtained at temperature of 1250℃, which is 70 ℃ lower than that of the undoped counterparts. Lower sintering temperature can result in finer WC grain growth; therefore, the P-doped WC-10Co alloys exhibited higher hardness than the undoped ones. But at the same time, P doping could lead to sacrifice of fracture toughness ofWC-10Co cemented carbides.
Sintering behavior, microstructure and microwave dielectric properties of Ba1+x(Mg1/3Nb2/3)O3 (-0.01 [less-than or equal to] x [less-than or equal to] 0.01) were investigated. An improvement of the degree of 1:2 order...
详细信息
Sintering behavior, microstructure and microwave dielectric properties of Ba1+x(Mg1/3Nb2/3)O3 (-0.01 [less-than or equal to] x [less-than or equal to] 0.01) were investigated. An improvement of the degree of 1:2 ordering and sinterability was found in Ba-deficient Ba(Mg1/3 Nb2/3)O3 because there existed Ba vacancies. Excessive Ba inhibits the sintering and the degree of 1:2 ordering. It was proposed that excessive Ba exist in grain boundary and inhibit the movement of grain boundary. Therefore, the sintering was restrained. Ba-deficiency had little effect on dielectric constant of Ba(Mg1/3Nb2/3)O3 ceramics. With Ba-deficiency increasing, Qf value decreased drastically.
The effects of glass flit on the sintering and electric properties of PMN-PT textured ceramics were investigated. The glass frits, including PbO, Bi2O3 and ZnO, were selected since liquid phase sintering lowered the P...
详细信息
The effects of glass flit on the sintering and electric properties of PMN-PT textured ceramics were investigated. The glass frits, including PbO, Bi2O3 and ZnO, were selected since liquid phase sintering lowered the PMN-PT sintering temperature. The piezoelectric properties of PMN-PT ceramics with glass frit addition are strongly dependent on the densification. The addition of glass frits into PMN-PT matrix reduced the sintering temperature to 1 100℃ instead of 1 150 ℃ for samples without glass. The piezoelectric coefficients （d33） of PMN-PT textured ceramics achieved 568 pc/N with 1 wt% excess PbO.
Polycrystalline samples of Sm partially filled skutterudites SmyFexCo4-xSb12 were prepared by melting and Spark Plasma Sintering technique. The results of Rietveld refinement showed that the obtained SmyFexCo4-xSb12 s...
详细信息
Polycrystalline samples of Sm partially filled skutterudites SmyFexCo4-xSb12 were prepared by melting and Spark Plasma Sintering technique. The results of Rietveld refinement showed that the obtained SmyFexCo4-xSb12 samples possessed filled skutterudite structures. The thermal parameter （B） of Sm is larger than that of Sb, Fe, and Co, indicating that Sm ＂rattled＂ in Sb-icosahedron voids. The effects of filling atom Sm on thermoelectric properties of these compounds were investigated. With the increase of Sm filling fraction （y）, electrical conductivity decreased, Seebeck coefficient increased and had a maximum value when y was 0.38; thermal conductivity reduced and had a minimum value when y was 0. 32. At 750 K, the highest figure of merit of 0.68 was obtained for Sm0.32Fe1.47Co2.53Sb12.
The synthesis of Ti3AlC2/TiB2 composites was studied by in-situ spark plasma sintering with different volume content of TiB2. Results indicated the bulk Ti3AlC2/TiB2 was fabricated by SPS, which soaked for 8 min under...
详细信息
The synthesis of Ti3AlC2/TiB2 composites was studied by in-situ spark plasma sintering with different volume content of TiB2. Results indicated the bulk Ti3AlC2/TiB2 was fabricated by SPS, which soaked for 8 min under a pressure of 30 MPa at 1250°C. The properties of composites was great increased with the addition of TiB2;the Vicker's hardness increased with addition of TiB2 content, the maximum value is 10.4 GPa. The maximum flexural strength and fracture toughness reached maximum value, which were 696 MPa and 6.6 MPa·m1/2 when the volume content of TiB2 was 10%.
作者：
CAO MingHe TIAN Wei LI MingFa SUN WenHua HU MingJi LIU HanXingState Key Laboratory of Advanced Technology for Materials Synthesis and Processing
Wuhan University of Technology Wuhan 430070 China State Key Laboratory of Advanced Technology for Materials Synthesis and Processing Wuhan University of Technology Wuhan 430070 China State Key Laboratory of Advanced Technology for Materials Synthesis and Processing Wuhan University of Technology Wuhan 430070 China State Key Laboratory of Advanced Technology for Materials Synthesis and Processing Wuhan University of Technology Wuhan 430070 China State Key Laboratory of Advanced Technology for Materials Synthesis and Processing Wuhan University of Technology Wuhan 430070 China State Key Laboratory of Advanced Technology for Materials Synthesis and Processing Wuhan University of Technology Wuhan 430070 China
The NaNbO3 powders were synthesized and their crystal structure changes were analyzed by ultrahigh pressure up to 6 *** results indicate that the pure NaNbO3 powders can be synthesized at 300℃ under a pressure of 4 G...
详细信息
The NaNbO3 powders were synthesized and their crystal structure changes were analyzed by ultrahigh pressure up to 6 *** results indicate that the pure NaNbO3 powders can be synthesized at 300℃ under a pressure of 4 GPa, to sig- nificantly restrain the Na element volatilization compared with the traditional syn- thesis method. It is found that the crystal structure of synthesized NaNbO3 changes from low symmetry to high symmetry with the increase of the pressure.
暂无评论