检索结果-内蒙古大学图书馆

26th Chinese control Conference, CCC 2007

作者： Mei, Shengwei Che, Wenyan State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Beijing 100084 China

ISBN: (纸本)7900719229

This work is concerned with the small signal stability problem in multi-machine systems. By means of H∞ theory, firstly the math model with disturbances is constructed;and secondly, the excitation control law for each generator is designed based on solving Riccati Equation. Finally, simulations performed on 4-machine system shows that the proposed H ∞ method has more advantages over LQR method in both damping ratio and H∞ norm of the corresponding closed-loop system and so can enhance the small signal stability of power system greatly.

关键词： Electric power systems

来源：评论

学校读者我要写书评

暂无评论

Comprehensive power-supply planning for active distribution system considering cooling,heating and power load balance

引用

Journal of Modern power systems and Clean Energy 2015年第4期3卷 485-493页

作者： Xinwei SHEN Yingduo HAN Shouzhen ZHU Jinghong ZHENG Qingsheng LI Jing NONG State Key Lab of Control and Simulation of Power Systems and Generation Equipments Department of Electrical EngineeringTsinghua UniversityBeijing 100084China Grid Planning&Research Center Guizhou Power Grid CooporationCSGGuiyang 550002China

An active distribution system power-supply planning model considering cooling,heating and power load balance is proposed in this paper.A regional energy service company is assumed to be in charge of the investment and operation for the system in the *** expansion of substations,building up distributed combined cooling,heating and power(CCHP),gas heating boiler(GHB)and air conditioner(AC)are included as investment planning *** terms of operation,the load scenarios are divided into heating,cooling and transition ***,the extreme load scene is included to assure the power supply reliability of the *** results demonstrate the effectiveness of the proposed model and illustrate the economic benefits of applying distributed CCHP in regional power supply on investment and operation.

关键词： Active distribution system Combined cooling heating and power(CCHP) power-supply planning Load balance

来源：评论

学校读者我要写书评

暂无评论

Switching Current Imbalance Mitigation for Paralleled SiC MOSFETs Using Common-mode Choke in Gate Loop 12

Switching Current Imbalance Mitigation for Paralleled SiC MO...

引用

12th Annual IEEE Energy Conversion Congress and Exposition, ECCE 2020

作者： Liu, Jiye Zheng, Zedong Tsinghua University State Key Lab of Control and Simulation of Power Systems and Generation Equipments Department of Electrical Engineering Beijing China

ISBN: (纸本)9781728158266

Paralleling SiC MOSFETs is a popular way to increase the current capacity. However, due to asymmetric layout, device parameter mismatch and other factors, imbalanced switching or dynamic current is observed among the paralleled switches in multi-device paralleling application which results in unequal switching loss, challenging the security and reliability of the system. In this paper, a common-mode choke in the gate loop is proposed and analyzed to suppress the imbalanced switching current induced by asymmetric layout in a half-bridge configuration with a Kelvin-source connection. The mechanism of the proposed method is comprehensively investigated to show that though the common-mode choke is placed in the gate loop, it can also mitigate the imbalanced current caused by asymmetric power loop. And it also shows that only the leakage inductance of the choke is seen in the gate loop and thus the switching speed is not expected to be influenced. The proposed method can be easily extended to multi-device paralleling application and the switching transients is hardly influenced by the common-mode choke. simulation and experimental results are presented to verify the proposed method. © 2020 IEEE.

关键词： Silicon

来源：评论

学校读者我要写书评

暂无评论

Distribution line automation system based on non-communication protection in the case of symmetrical fault

Distribution line automation system based on non-communicati...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Yin, Diqing Liu, Kun Dong, Xinzhou Shi, Shenxing Xu, Gang Wang, Kai North City Branch of Shanghai Power Company Shanghai 200072 China Status Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

ISBN: (纸本)9781424496198

Distribution line non-communication protection (DNCP) can quickly and selectively isolate unsymmetrical fault, but the performance of this distribution line automation system is not satisfying in the case of symmetrical fault. This paper proposes a scheme which can quickly isolate symmetrical fault and block the operation of BPS: DNCP which is closed to the source can operate instantaneously, that can avoid overheating damage of electrical equipment;when the magnitude of voltage falls, BPS will detect the magnitude of negtive voltage two cycles ago to make a decision, that can avoid the process of connecting to permanent fault and tripping again for the ring main unit. EMTP simulation results show the effectiveness of the scheme. © 2011 IEEE.

关键词： Automation

来源：评论

学校读者我要写书评

暂无评论

Analyses on frequency transmission characteristic of traveling wave in distribution power system

Analyses on frequency transmission characteristic of traveli...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Wang, Jun Shi, Shenxing Dong, Xinzhou Wang, Bin State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

ISBN: (纸本)9781424496198

Under the skin effect caused by the alternating electromagnetic field, the transmission line parameters changes with frequency, and different line resistivity, surge impedance, wave speed are presented in one line under the different frequency bands of signal. This phenomenon is usually called Frequency transmission characteristic, which is mainly discussed in this paper. This paper first studied the line resistivity, wave speed and surge impedance of zero-mode component and line-mode component in different frequency bands. Then, the line structure and its effection on Frequency transmission characteristic are presented. Last, the frequency transmission characteristic on a certain line fault is discussed based on a typical distribution system model. The research in this paper is meaningful for future study on the fault feeder selection and fault location technology based on traveling wave in the distribution system. © 2011 IEEE.

关键词： Wavelet transforms

来源：评论

学校读者我要写书评

暂无评论

Research on the process of power flow transferring and its identification method

Research on the process of power flow transferring and its i...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Liu, Kun Dong, Xinzhou Wang, Bin Shi, Shenxing State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

ISBN: (纸本)9781424496198

This paper analyzes the general process of power flow transferring and divides it into four parts: 1) the process of first phase selection after fault occurs;2) the process of selective action at the first time;3) the process of second phase selection and status confirmation;4) the process after status confirmation. It points out that the issue of asymmetrical flow transferring is a critical process which must be put emphasis on. Then it proposes a method to identify this process, and discuss different solution methods. © 2011 IEEE.

关键词： Electric load flow

来源：评论

学校读者我要写书评

暂无评论

A novel fault locator for power distribution system with neutral non-effectively grounded

A novel fault locator for power distribution system with neu...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Shi, Shenxing Dong, Xinzhou State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

ISBN: (纸本)9781424496198

Fault locator for power distribution system with neutral non-effectively grounded should locate phase-to-phase fault and single-phase-to-ground fault respectively. For phase-to-phase fault, the point can be located by power-frequency impedance. However, for single-phase-to-ground fault with limited power-frequency current not more than load current, a novel fault location technology should be developed. The paper will present a practical single-phase-to-ground fault location based on fault generated traveling waves acquired from one phase current transducer and zero sequence current transducer at first. Then implementation of the novel fault locator is proposed including hardware design and software flowchart. At last field tests will be made to verify the feasibility of the fault locator. © 2011 IEEE.

关键词： Transducers

来源：评论

学校读者我要写书评

暂无评论

Steady-state security analysis of power system based on the operational reliability theory 3

Steady-state security analysis of power system based on the ...

引用

3rd International Conference on Reliability of Electrical Products and Electrical Contacts, ICREPEC 2009

作者： Zou, Xin Cheng, Lin Sun, Yuanzhang Department of Electrical Engineering State Key Lab of Control and Simulation of Power Systems and Generation Equipments Tsinghua University Beijing100084 China

ISBN: (纸本)9789889968489

Conventional steady-state security analysis have to compute the faults belonging to the predefined faults set in turn with out considering the small probability of the occurrence of some faults under certain circumstances. Although its results reflect the violation of the components precisely, they can not figure out how the violation affects the security of the system. The steady-state security analysis based on the operational reliability theory applies the state-depended models of the components in order to find the faults which would happen with high probability. As a result, only these faults should be calculated to decrease the computation time considerably. Further more, the reliability indices indicate the probability of the violation of the component as well as the influence of the violation on the system security, so that the security of the system can be evaluated comprehensively. IEEE RTS-79 test system is adopted in this paper to illustrate the differences between the conventional and the new steady-state security analysis methods. By contrast, it can be concluded that steady-state security analysis based on the operational reliability theory can calculate the influence of the variation of the component failure probability on the system security more specifically, which making the evaluation results more close to the practical operating system Copyright © 2009 by International Academic Publishers Ltd.

关键词： Reliability theory

来源：评论

学校读者我要写书评

暂无评论

Single phase grounding fault location based on frequency domain characteristics of fault current

Single phase grounding fault location based on frequency dom...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Jiang, Bo Shi, Shenxing Dong, Xinzhou Wang, Bin State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

ISBN: (纸本)9781424496198

This paper studies the fault current frequency spectrum characteristics of single phase ground fault in ungrounded distribution networks, and the fault location method based on it. Firstly, it analyzes the production mechanism of 2nd major frequency component, and the relationship between the 2nd major frequency component and series resonance frequency of the faulted line. Secondly, from the perspectives of lumped-parameter circuit, the relationship between 2nd major frequency component and fault location is deduced. simulation cases are used to confirm the relationship. Last, the impact of load and initial fault phase angle on the 2nd major frequency component are researched. simulation research proves the feasibility of the fault detection and location method based on frequency domain characteristics. © 2011 IEEE.

关键词： Electric fault location

来源：评论

学校读者我要写书评

暂无评论

Estimating the electromechanical oscillation characteristics of power system based on measured ambient data utilizing stochastic subspace method

Estimating the electromechanical oscillation characteristics...

引用

2011 IEEE PES General Meeting: The Electrification of Transportation and the Grid of the Future

作者： Jingmin, Ni Chen, Shen Feng, Liu State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

ISBN: (纸本)9781457710018

Estimating low-frequency oscillation modes and the corresponding mode shapes based on ambient data from WAMS measurements has a promising prospect of application in power system analysis and control. The present approaches estimate the modes and mode shapes respectively, which greatly reduce the computational efficiency. Besides, there is no good solution for the problem of discriminating real modes from the spurious ones caused by numerical error. A method based on stochastic subspace method was proposed in this paper. By choosing the angle measurements of all buses as input signals for the method, the modes and simultaneously the corresponding mode shapes of any bus can be estimated conveniently. By introducing the idea of reference channels, the computation complexity was substantially reduced without decreasing the accuracy. Stabilization diagrams technique was introduced to discriminate the real modes from the spurious ones. The test case based on the IEEE-118 system indicated that the method proposed is satisfying in respect of both computational efficiency and accuracy of results. © 2011 IEEE.

关键词： Computational efficiency

来源：评论

学校读者我要写书评

暂无评论

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案：

请选择收藏分类：

通借通还

建议与咨询 留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案： 新增检索档案 确定 取消

请选择收藏分类： 新增自定义分类 确定 取消

通借通还

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

请选择保存的检索档案：

请选择收藏分类：