检索结果-内蒙古大学图书馆

International Conference on Electrical Machines and systems (ICEMS)

作者： Gaoyu Zou Zhengming Zhao Liqiang Yuan Xuesong Wang Ting Lu State Key Laboratory of Control and Simulation of Power System and Generation Equipment Department of Electrical Engineering Tsinghua University Beijing China

The key parameters of SOA (safe operating area) of semiconductor devices are hard to be measured when converter is operating, which is not helpful to protect converter at any time. On the other hand, surplus estimating method is widely used to design the main circuit. In order to guarantee the whole system works safely and improve utilization rate of devices, the concept of SSOA (systematic safe operating area) is presented. By determining the relationship of key parameters between devices and converter, the expression of SSOA is described quantitatively. Then it is implemented as a basic rule to design a back-to-back converter based on IGBT for 55kW induction motor optimally. Rated value of DC-link voltage and grid filter of the system is obtained reasonably as well.

关键词： Inductance Insulated gate bipolar transistors Rectifiers power harmonic filters Semiconductor optical amplifiers Induction motors

来源：评论

学校读者我要写书评

暂无评论

Study on Over-Voltage of 220 kV Transformer＇s Neutrals and Protection Strategy

引用

Journal of Energy and power Engineering 2011年第11期5卷 1102-1108页

作者： H.P. Yu S.M. Chen P.C. Yang H. Yin G.L. Wu State Key Lab of Control and Simulation of Power Systems and Generation Equipments Department of Electrical Engineering Tsinghua University Beoing 100084 China Chongqing Electric Power Research Institute Chongqing 401123 China

In order to limit short-circuit current and satisfy the need of relay setting, only part of the 220 kV power transformer is grounded, so on the neutrals of ungrounded transformers will appear the over-voltage. Currently the value of over-voltage on transformer neutral point and the corresponding protection strategy is based on theoretical formula. This article uses the PSCAD/EMTDC software to calculate the over-voltage on the neutral point of 4 ungrounded power transformers in Chongqing 220 kV power grid. The result shows that the power frequency transient over-voltage on the neutrals may reach 178 kV. If the single-phase grounding fault occurs in ungrounded power system, the power frequency over-voltage on the neutrals will be more serious and rise to 138.6 kV. Non-full phase operation may cause serious ferro-resonance over-voltage on the neutrals of no-load transformer, which may last for seconds and may rise to 723.7 kV, causing serious threat to the transformer neutrals and line-side equipment. The article also studies the gap parameter which should be taken on the neutrals of 220 kV transformers at the end.

关键词： Neutral point power transformer arrester gap power frequency over-voltage lightning over-voltage.

来源：评论

学校读者我要写书评

暂无评论

Design, simulation and analysis of the low stray inductance bus bar for voltage source inverters

Design, simulation and analysis of the low stray inductance ...

引用

International Conference on Electrical Machines and systems (ICEMS)

作者： Liqiang Yuan Hualong Yu Xuesong Wang Zhengming Zhao State Key Laboratory of Control and Simulation of Power System and Generation Equipment Department of Electrical Engineering Tsinghua University Beijing China

Hard-switching technique under the high voltage and high current is one of main trends of high power inverters. Under this switching mode, the stray parameters of the commutating loops, especially the stray inductance of the DC bus bar, have significant influence on the switching process, electromagnetic interference and component stress of the semiconductor switches. It becomes one of the key points for the safe operation of inverters. Based on an actual 55 kW inverter, the design, simulation and analysis for its bus bar is described in this paper. The bus bar model is built with the method of Partial Element Equivalent Circuit (PEEC), and the stray parameters are extracted from PEEC model and applied in the circuit simulation. Compared with the experimental results, the modeling validity is proved, and the simplified modeling process and design principles for complex physical bus bar are presented.

关键词： Integrated circuit modeling Equivalent circuits Inductance Inverters Capacitance Conductors Analytical models

来源：评论

学校读者我要写书评

暂无评论

Research of protection communication system in process level of intelligent substation

Research of protection communication system in process level...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Xu, Fei Wang, Bin Dong, Xinzhou Cao, Runbin Liu, Kun Yang, Yuelin Wu, Tingting State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Beijing 100084 China College of Information and Electrical Engineering China Agricultural University China School of Electrical Engineering and Renewable Energy China Three Gorges University Yichang 443000 China

ISBN: (纸本)9781424496198

The paper mainly focuses on the communication problem based on IEC61850 communication protocol. As in the process level communication system: MU (Merging Unit)-Switch-DIPC (Digital Integrated Protection and control system), the stability of SMV packets transmission is very important. The transmission delay of the process level communication is the key problem that may restrict the protection algorithm and capability. In the meantime, GPS synchronization problem of MUs, protection capability of the integrated protection device and stability of SMV message transmission based on the existing DIPC(DIP-01) system will also be discussed in the paper. Through the experiment and analysis, the paper gives out the key factors that lead to the message transmission delay and packets loss. The work at last gives out some primary ideas to improve the protection capability. © 2011 IEEE.

关键词： Ethernet

来源：评论

学校读者我要写书评

暂无评论

Demand analysis of the information sharing among multi-bays through the process networks in intelligent distribution substation

Demand analysis of the information sharing among multi-bays ...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Yang, YueLin Wang, Bin Wen, BoYing Dong, XinZhou Wu, TingTing Liu, Kun College of Information and Electrical Engineering CHINA Agricultural University Beijing 100083 China State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Beijing 100084 China School of Electrical Engineering and Renewable Energy China Three Gorges University Yichang 443000 China

ISBN: (纸本)9781424496198

Multi-bay information sharing has very important significances for the the enhancing of the relay characteristics and improving of the system control methods. With the summary of distribution substation busbar protection, small current grounding fault line selection, non-communication double-circuit line protection, reactive power and voltage control, low frequency load shedding control programmes, It analyse the needs of the information sharing among multiple bays and the application of integrated protection. © 2011 IEEE.

关键词： Electric grounding

来源：评论

学校读者我要写书评

暂无评论

Designation and development of hardware platform for intelligent ter-minal in 126kV smart substation

Designation and development of hardware platform for intelli...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Sun, Tong Wang, Bin Dong, XinZhou Zhang, ShuJian Kang, MingCai Cao, RunBin School of Automation Nanjing University of Science and Technology Nanjing Jiangsu 210094 China State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China Electrical Engineering and Automation Hefei University of Technology Hefei Anhui 230009 China

ISBN: (纸本)9781424496198

According to the demand of 126kV intelligent switch with intelligent operative box, an intelligent terminal device by using cooperation control of embedded CPU (STM32F103ZET6 ARM) and Field Programmable Gates (Cyclone II EP2C8Q208C8 FPGA), which is up to the IEC61850 standard, is designed in this paper. Research program of the device is discussed. Starting from the modularization structure design, function of each module, circuit design and implementation method were introduced in detail. A hardware platform was established according to the design. Finally, the article confirmed the correctness of the hardware platform primarily through experimental method. © 2011 IEEE.

关键词： Field programmable gate arrays (FPGA)

来源：评论

学校读者我要写书评

暂无评论

Discussion of protection and cascading outages from the viewpoint of communication

Discussion of protection and cascading outages from the view...

引用

International Conference on Advanced power System Automation and Protection (APAP)

作者： RunBin Cao Xinzhou Dong Bin Wang Kun Liu Status Key Lab of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

power grid and communication network, which depends on each other to provide proper functionality, are becoming more and more coupled together. Failure of a fraction of nodes in communication networks may lead to a failure even a cascade of failures in power grid. Wide area protection is highly dependent on communication. The failure of communication in some part of wide area protection system will affect the realization of the function to prevent cascading outages and result in serious consequences. Based on Manchester, OPA and hidden failure cascading failure models and considered the feature of relay protection, an improved cascading failure model is established. Then it is used to analyze the dynamic process of communication fails in wide area protection system and IEEE 30 bus system is employed to demonstrate the efficiency of the proposed method. Results show that communication failure in protection system will accelerate the cascading outages of power grid. Effective solutions to reduce the communication risk are discussed. The work of this paper is available for reference to analyze the process of cascading outages and design protection system preventing cascading outages.

关键词： power system faults power system protection Load modeling Wireless application protocol power system stability Load flow power grids

来源：评论

学校读者我要写书评

暂无评论

Applicable range analysis of optimized single-terminal fault location algorithm

Applicable range analysis of optimized single-terminal fault...

引用

International Conference on Advanced power System Automation and Protection (APAP)

作者： Tian-xiao Huang Xin-zhou Dong Shen-xing Shi Bin Wang State Key Lab of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

Impedance method and single terminal travelling wave method are analyzed in paper, applicable scope of optimized solution is presented. Impedance method is of high robustness but low accuracy. Single terminal travelling wave method offers high accuracy but poor robustness. Optimized solution combines these two methods together, takes advantages of both methods. It is a great enhancement to single terminal fault location. This paper analyzed theoretical basis of optimized solution, proposed the calculation algorithm of fault location range using impedance method. Analyses of impedance method and single terminal travelling wave method show that the optimized solution is suitable for engineering application. Error analysis is proved correct by simulation.

关键词： Fault location Impedance Impedance measurement Transmission line measurements power transmission lines Frequency modulation Surges

来源：评论

学校读者我要写书评

暂无评论

Traveling waves based protection relaying of power lines

Traveling waves based protection relaying of power lines

引用

International Conference on Advanced power System Automation and Protection (APAP)

作者： Shenxing Shi Xinzhou Dong Shiyong Wang Status Key Lab of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China

With high speed data sampling technology development, fault generated high-frequency signals can be got, in which fault generated traveling waves reflects fault location, fault type and faulted equipment so on from different ways of traditional power-frequency information. Fault generated traveling waves may help to improve protection relaying. The paper will review fault generated traveling waves and its physical base at first. Then two cases will be presented to exemplify the advantage of traveling waves based protection relaying. One is that fault generated traveling waves with the speed of light can be used to protect UHV long transmission lines independent of capacitive charging current. The other is traveling wave will be applied to detect single-phase-to-ground fault in power distribution system with neutral non-effectively grounded. At last the paper will conclude with implementation of traveling wave based protection relaying.

关键词： Relays Circuit faults Integrated circuit modeling power transmission lines

来源：评论

学校读者我要写书评

暂无评论

IEC61850-based information modeling of 126KV intelligent terminals

IEC61850-based information modeling of 126KV intelligent ter...

引用

2011 International Conference on Advanced power System Automation and Protection, APAP 2011

作者： Zhang, Shu-Jian Wang, Bin Sun, Ming Dong, Xin-Zhou Sun, Tong Cao, Run-Bin Electrical Engineering and Automation Hefei University of Technology Baohe District Hefei 230009 China State Key Lab. of Control and Simulation of Power Systems and Generation Equipments Dept. of Electrical Engineering Tsinghua University Haidian District Beijing 100084 China School of Automation Nanjing University of Science and Technology Nanjing Jiangsu 210094 China

ISBN: (纸本)9781424496198

The stability and reliability of the intelligent terminal's receiving information affects its control of intelligent switch in operation directly. To achieve reliable intelligent communications terminals, with techniques and methods of IEC61850 modeling, the paper completed the 126KVGIS intelligent terminal information model based on the analysis of its information characteristics, and established the hardware platform with data model and logical nodes provided by IEC61850. Thus it has a certain practical significance to promote the standard construction, operation and management of intelligent substation, and lead the digital process of process layer devices. © 2011 IEEE.

关键词： Digital devices

来源：评论

学校读者我要写书评

暂无评论

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案：

请选择收藏分类：

通借通还

建议与咨询 留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

时间限定

文献类型

馆藏选择

核心期刊

语言

文献类型

帮助

文字说明：

检索规则说明：

检索范例：

分类表

所选分类

限定检索结果

文献类型

馆藏范围

日期分布

学科分类号

主题

机构

作者

语言

请选择保存的检索档案： 新增检索档案 确定 取消

请选择收藏分类： 新增自定义分类 确定 取消

通借通还

建议与咨询留下您的常用邮箱和电话号码，以便我们向您反馈解决方案和替代方法

请选择保存的检索档案：

请选择收藏分类：